Features:
These Nylon bodied safety padlocks with a nylon shackle are a cost effective solution to meet your lockout requirements
Standard safety/owner labelling on both sides included
Non-conductive reinforced shackle
Key number engraved on the padlock as standard - control your key numbers like never before
High security dimple key cylinder to give up to 100,000 differs
Key works both ways for enhanced convenience
The key design makes it impossible to be duplicated
Key retaining when open for increased safety
Manufactured from heavy duty flexible nylon with 80mm clearance
Can easily be manipulated into place
Ideal for difficult applications
Accepts up to 6 padlocks with a shackle diameter up to 9mm
Non conductive Applications
The Master Lock No. 491B Grip Tight™ Circuit Breaker Lockout Device fits wide or tall breaker toggles typically found on hi-voltage/hi-amperage breakers. The innovative patented Grip Tight™ design effectively locks out circuit breakers with a simple thumb turn and then close clamping handle for a tight grip on the toggle.
This Master Lock® Grip Tight™ Circuit Breaker Lockout device helps prevent accidental engagement of electrical circuits during maintenance. It works on switches with or without holes and uses cleats, with clamp-on lockout, to assure positive restraint for breakers with long sliding switch throws.
This National Marker large circuit breaker lockout locks out circuit breakers with single toggles up to .8" thick and 3" wide and features and easy installation.
Manufactured from a 1/25" thickness high impact styrene with a brass eyelet to take a shackle diameter of up to 3/8". These tags easily pass the OSHA 50lbs "pull force" offer a double sided, easy to write surface.
They offer a double sided, easy to write and clean surface.
We advise these tags are best used with a non-permanent water based ink pen (RWPT01 recommended) and this will give a good operational life. An oil-based permanent marker pen (RWPT02) will allow for good identification but will only work well for a single use.
Manufactured from a double layer of high impact styrene with a brass eyelet to take a shackle diameter of up to 8mm. These tags easily pass the 50lbs "pull force" offer a double sided, easy to write surface.